Take a look at our
ThinkPads.com HOME PAGE
For those who might want to contribute to the blog, start here: Editors Alley Topic
Then contact Bill with a Private Message

A Question about battery rebuild for 600E

Older ThinkPads.. from the 600, the 7xx, the iSeries, 300, 500, the Transnote and, of course, the 701
Post Reply
Message
Author
CreeperLoop
Posts: 2
Joined: Mon Jul 20, 2020 4:52 am
Location: Shanghai, China

A Question about battery rebuild for 600E

#1 Post by CreeperLoop » Mon Jul 20, 2020 5:18 am

Hey guys, : )

I'm new to here and recently bought a IBM 600E with a dead battery. Did some researches and it seemed like the chip inside the battery won't need to be reprogrammed (like T4x Series) after changing the cells. Therefore I'd like to give it a shot, using fresh Li-polymer cells with similar size to the original 18650 sets.

The question is that I found some extra soldering points than positive and negative poles on the circuit, and the layout of those PCBs are kind of hard to find. Could anyone who has experience on rebuilding these batteries share the techniques on how to solder the wires and the ways to check the voltages of those pins?

Many thanks!
Jim

Post Reply
  • Similar Topics
    Replies
    Views
    Last post

Return to “ThinkPad Legacy Hardware”

Who is online

Users browsing this forum: No registered users and 29 guests