wireless frustration

[llama_thumper]

hope anybody can give me a hint...

i'm leaving in a day and cannot get my wireless setup to work.
i have a t40p and the newest ibm access as well as wifi drivers.
today at the airport i could not connect - the network scanner couldn't even locate any network, whilst windows did.
previously, it was able to locate them, but not connect (so i cleaned everything out and installed it again... which has led to the above).
can anyone give me any hints on what to do to _completely_ get rid of all my wireless settings, drivers, etc, and make a fresh, nice, clean install and get things working? i have managed previously to connect to my home network, however i have always failed to connect (at least using IBM access) to public wireless hubs, which is extremely frustrating as I dont get any internet access when I could be getting it.

so mayve the way out is just to completely deepclean the notebook of any wireless settings whatsoever and make a fresh start?
i would appreciate any comments/ideas/suggestions!

btw, my card is the "802.11a/b Wireless(MPCI) (IBM Dual-Band and 11a/b/g Wireless Mini-PCI Adapter )".

any help appreciated!

[Gonzo]

Not sure what the trouble is, but IBM support can probably walk you through it. Or you can de-install and re-install to see if that clears things up.

[Daniel]

If worse comes to worse.. just get rid of the IBM stuff and use the Windows one

[G-Man]

If you use IBM Access Connections make sure Wireless Zero is turned off. Also you can remove Q826942 and Q815485 Windows Hotfixes that had trouble with the wireless dirver.

Regards,
G-Man