matshita UJDA765 driver WOn't Detect

Message

aznmikex215 · #1 Post by **aznmikex215** » Thu Dec 15, 2005 10:23 pm

matshita UJDA765 driver WOn't Detect and i cannot burn.

I formatted my T43 and reinstalled all the windows updates and everything inside the software installer. Everything works fine EXCEPT THE CDRW/DVD.

Nero won't detect it as being writable. Under the drives properties, my defualt: Recording is enabled.

THe drive shows up in "My COmputer" as DVD/CD-RW but NERO is not detecting it or showing its write speed.

I cannot burn anything. ive tried 2 different CD burning software and the the CDRW does not appear on its list of drives to burn to.

Is there a MATSHITA or IBM driver? I dont think the Microsoft driver is working very well. I cannot find it on the Lenovo website.

HELP! THANKS!

christopher_wolf · #2 Post by **christopher_wolf** » Thu Dec 15, 2005 10:52 pm

Hmm, have you tried the software installer or the Driver matrix for your Model?

aznmikex215 · #3 Post by **aznmikex215** » Thu Dec 15, 2005 11:43 pm

The Lenovo website doesnt have a driver listed for the Drive. All it has is the DLA update, which i downloade dbut it does not install saying it didnt find software to update.

The have a DOS driver for DOS users and win 3.1 but thats not what i need.

aznmikex215 · #4 Post by **aznmikex215** » Thu Dec 15, 2005 11:47 pm

well i just checked microsoft's website and there is a "NON CRITICAL" update for "Lenovo Hardware" which i hope fixes the problem. i will report back shortly!

aznmikex215 · #5 Post by **aznmikex215** » Fri Dec 16, 2005 12:06 am

hmmm installed the "Lenovo Hardware" update form microsoft and nothing happened.

I did discover that i can write a CD using the windows CD wizard. But i still cannot get any of my Nero's to detect my drive. Maybe i need a newer version.

1ravendog · #6 Post by **1ravendog** » Fri Dec 16, 2005 1:35 pm

Mine died now too.

Says it cannot load the drivers in device manager.

No previous drivers to roll back to.

I don't even see the drivers in the software updater.

Tried removing and re-installing drivers and device in windows but it still comes up with the ! in the device manager.

I also did not see any drivers at all on the Lenovo site, how can that be?

Any ideas would be helpful.

Thanks,
Mark

#7 Post by **GomJabbar** » Fri Dec 16, 2005 1:50 pm

Try this. Go to Start > Control Panel > System > Hardware > Device Manager. Right click on everything under IDE ATA/ATAPI Controllers and uninstall. Now reboot. Go back into Device Manager. Both Primary IDE controller and Secondary IDE controller should be using DMA mode - or a version of it like Ultra DMA. You should not be using PIO mode.

Now see if optical drive works properly.

aznmikex215 · #8 Post by **aznmikex215** » Sat Dec 17, 2005 10:10 am

Got it fixed! You just gotta use Newer burning software. I originially tried with Nero 5.5, but i guess that is too old. Nero 7 Premium works great! THanks!

1ravendog · #9 Post by **1ravendog** » Sat Dec 17, 2005 10:34 pm

Got nervous about uninstallng so much stuff i did not understand and got by with a system restore to a few days back.

the advice was very appreciated though.

Thank you,
Mark

aznmikex215 · #10 Post by **aznmikex215** » Sun Dec 18, 2005 1:36 am

I attempted this and my computer got stuck in an endless Bluescreen of death reboot sequence.

I just reloaded to the "last known good settings". and everyhting was fine. But if your drive isnt detecting, just try a newer version of your burning software. Nero 7 works fine with this drive.

GomJabbar wrote:Try this. Go to Start > Control Panel > System > Hardware > Device Manager. Right click on everything under IDE ATA/ATAPI Controllers and uninstall. Now reboot. Go back into Device Manager. Both Primary IDE controller and Secondary IDE controller should be using DMA mode - or a version of it like Ultra DMA. You should not be using PIO mode.

Now see if optical drive works properly.

matshita UJDA765 driver WOn't Detect

matshita UJDA765 driver WOn't Detect

BTTT!!!!!

Who is online