770z will not boot

Message

John560e · #1 Post by **John560e** » Sat Feb 04, 2006 6:11 am

My 770z boots to display memory and IBM logo, but will not continue. I have tried booting to EzSetup, F8, from floppy and with three different hard drives. However, it will not continue past memory post. I worked fine yesterday... any suggestions?

hjulian · #2 Post by **hjulian** » Sat Feb 04, 2006 6:24 pm

If you are working with a battery, remove it and try AC power only.

How long did you work with it yesterday? Overheating of memory, maybe?

Is everything sitting properly in its place? Check memory modules.

Check the keyboard, maybe there is a key being held down accidentally.

John560e · #3 Post by **John560e** » Sat Feb 04, 2006 6:59 pm

hjulian wrote:If you are working with a battery, remove it and try AC power only.

How long did you work with it yesterday? Overheating of memory, maybe?

Is everything sitting properly in its place? Check memory modules.

Check the keyboard, maybe there is a key being held down accidentally.

Thanks, I switched the RAM modules and it booted

xnosorrow · #4 Post by **xnosorrow** » Sat Feb 04, 2006 11:50 pm

Hello Sir,

i have the same problem with my 600e.. i tried to switch memory modules and it did'nt work.. any suggestions pls.. i will greatly appreciate it.. thanks in advance..