FS: 1.5 Pentium M (Banias Core) Processors

Message

brentpresley · #1 Post by **brentpresley** » Wed Apr 12, 2006 9:26 am

All in fully working condition. System pulls.

14-day DOA Warranty.

PLEASE NOTE THESE ARE 1MB CACHE (BANIAS) CORE CPUs. You DO NOT want to buy these to try a pinmod on. They are GREAT for upgrading a cheaper system from a Celeron M.

Intel Pentium M 1.5GHz (Banias Core)
- SL6F9
- 1.5GHz
- 400MHz Front Side Bus
- 1MB L2 Cache
2 AVAILABLE
$45 SHIPPED

HEAT
eBay feedback

Non-CC Paypal please.

PM me or email me at brentpresley@yahoo.com

Toine · #2 Post by **Toine** » Wed Apr 12, 2006 10:22 am

Intel Pentium M 1.7GHz (Banias Core)
- SL6N5
- 1.7GHz
- 400MHz Front Side Bus
- 1MB L2 Cache
1 AVAILABLE
$65 SHIPPED

Does this proccesor work in my T40? And is it easy to replace it yourself?

brentpresley · #3 Post by **brentpresley** » Wed Apr 12, 2006 11:02 am

Yes, it will work in a T40. To install it, you need to do the following:

Update your BIOS and Embedded controller to the latest versions, to ensure compatibility with the processor (just a precaution, may not be necessary).

Remove the keyboard, remove the palmrest (see the link below for details).
Remove the 3 screws hodling the heatsink down.
Wiggle the heatsink out by lifting it at a 30-degree angle (this will get it out from the top bezel that surrounds the keyboard, without actually having to remove the bezel).

The Processor will now be visible. Turn the screw on the socket 180 degrees to release the processor. Lift the processor up gently out of the socket and replace with the new one.

You will want to completely remove the IBM thermal pad and clean the heatsink with a mild organic solvent (ethanol, isopropyl alcohol, etc.).

Apply a small ammount of thermal grease (my personal favorite is Arctic Silver 5) to the shiny core on your new processor.

Reverse the above steps to install the heatsink, palmrest, and keyboard.

Turn on your T40 and enjoy the speed increase.

LINK to T40-T42 Hardware Manual:
ftp://ftp.software.ibm.com/pc/pccbbs/mo ... 192_01.pdf

brentpresley · #4 Post by **brentpresley** » Fri Apr 14, 2006 7:00 pm

1.7GHz chip has been sold.

Had to eBay it: 6870968977

Others are still available.

brentpresley · #5 Post by **brentpresley** » Tue Apr 18, 2006 10:43 am

Ryan T. · #6 Post by **Ryan T.** » Tue Apr 18, 2006 10:53 am

Brent will these chips work in any socket 478 motherboard?

You have some nice prices, and I'd like to make a "silent" media center PC.

Mr_Roboto · #7 Post by **Mr_Roboto** » Tue Apr 18, 2006 11:24 am

The Pentium M processors have 479 pins and will not fit into a socket 478 MB. Asus does make a daughter card that is compatible with specific Asus mother boards. Here are a couple of links Asus Product Description, ZipZoomFly CT-479, Review of the ASUS CT-479.

I also have thought about building a Silent media PC using mobile cpu's. If you end up going this rout please post your results in the Off Topic section of the forum. I would be interested in your results.

Regards and good luck,

~Rich

Mr_Roboto · #8 Post by **Mr_Roboto** » Tue Apr 18, 2006 11:42 am

OOPs Double posted

Ryan T. · #9 Post by **Ryan T.** » Tue Apr 18, 2006 11:48 am

Thanks very much for the link, very tempting!

brentpresley · #10 Post by **brentpresley** » Tue Apr 18, 2006 12:57 pm

Mr_Roboto wrote:The Pentium M processors have 479 pins and will not fit into a socket 478 MB. Asus does make a daughter card that is compatible with specific Asus mother boards. Here are a couple of links Asus Product Description, ZipZoomFly CT-479, Review of the ASUS CT-479.

I also have thought about building a Silent media PC using mobile cpu's. If you end up going this rout please post your results in the Off Topic section of the forum. I would be interested in your results.

Regards and good luck,

~Rich

This is NOT EXACTLY true. These are 478-pin, not 479-pin, but the pin-out is different from what is used for the P4. There ARE some 479-pin Pentium M processors, but for whatever reason, they are not as commonly used as the 478-pin Pentium M variety.

For more info:
http://processorfinder.intel.com

brentpresley · #11 Post by **brentpresley** » Fri Apr 21, 2006 1:03 pm

Down to 3 x 1.5GHz.

brentpresley · #12 Post by **brentpresley** » Mon May 08, 2006 6:44 am

brentpresley · #13 Post by **brentpresley** » Thu May 11, 2006 7:02 am

down to 2 x 1.5GHz

brentpresley · #14 Post by **brentpresley** » Sun May 14, 2006 3:56 pm

FS: 1.5 Pentium M (Banias Core) Processors

FS: 1.5 Pentium M (Banias Core) Processors

Who is online