T23 - Beep Error 1-3-3-1

Message

HelixX23 · #1 Post by **HelixX23** » Mon May 15, 2006 2:52 am

Hi...

Got a problem with my T23.

When it starts i get an Beep Error and a blank screen.

It beeps one time then three times again three times and one time.

In the BeepErrorSection in the Manual it says: 1.Dimm, 2. Mainboard

Now i decided to buy a new Mainboard.
I got it into and again: Beep Error 1-3-3-1

I now have only the monitor attached to the mainboard.
Ther are no FSU´s attached.
No UltraBay2000, no Networkcard, no Modem, No RAM...
and again: Beep Error 1-3-3-1

What am i doing wrong?

What kind of error might this be?
any suggestions?

If you need more Information please ask me!

THNX HelixX²³

danage · #2 Post by **danage** » Mon May 15, 2006 4:56 am

It will not start without RAM. Put in some RAM. RAM necessary for processor to work.

skou · #3 Post by **skou** » Tue May 16, 2006 12:00 am

That is definately a memory beep code. I've seen it numerous times.

All you need to do, is to get some memory for this T23.

steve

HelixX23 · #4 Post by **HelixX23** » Wed May 17, 2006 4:55 pm

I have checked one with 128MB and one with 64MB both failed.

I´ll check more of these RAMs maybe a working out of a friends T21.

skou · #5 Post by **skou** » Wed May 17, 2006 5:02 pm

Most likely, the memory from a T21 won't work on a T23.

You need to use some PC133 memory.

steve

HelixX23 · #6 Post by **HelixX23** » Fri May 19, 2006 4:52 am

yeehaa!!!

I´ve checked a 64MB pc100 - failed with beep error 1-3-3-1
I´ve checked a 128MB pc133 - failed with beep error 1-3-3-1

I´ve checked a 256MB pc133 original from IBM - *WORKING*

THANK YOU ALL FOR YOUR SUPPORT
I AM REALLY HAPP NOW!!

T23 - Beep Error 1-3-3-1

T23 - Beep Error 1-3-3-1

re

re

Who is online