easy lcd bezel question,help me please.

[dannydoo]

I changed my lcd 14.1 r40
it has the 2 antennas on both sides

I had to do it twice because I didt route the wires under the side screws.
Now IM having a problem where the bezel wont snap shut completely at the top 2 corners.

The thing is,I dont know if the little square antena pieces need to be flush withh the frame of the screen,or flush inside the inner part of the bracket,or flush on the outer side of the bracket?

The way it is now,if I remove the bezel,the little board for the antenna is on an angle, You can see the whole boardif you pull the bezel,not just the side of it.

Best way to descrbe question would be

If you pull the bezel......should you see the antenna boards complete face? Or should you only see the side of that board?

the bezel isnt comprimised in any way all the snaps and locks are great condition.

I pulled it apart so long i forgot.
IBM has movies but I didnt find one for that.

Thanks
Dan