CPU-modded 600X draining battery

Older ThinkPads.. from the 600, the 7xx, the iSeries, 300, 500, the Transnote and, of course, the 701
Post Reply
Message
Author
Grey Area
Freshman Member
Posts: 76
Joined: Mon Sep 19, 2005 12:02 pm
Location: Koblenz, Germany

CPU-modded 600X draining battery

#1 Post by Grey Area » Tue Dec 19, 2006 11:28 am

Recently I replaced the 650MHz P3M on my 600X with the 850MHz-version, and I notice the running time has decreased significantly. Right before the switch I got well above two hours, more than three if I kept calm. Now with the new CPU the machine drains the battery in 45 minutes doing nothing but showing the desktop (Ubuntu/Gnome). Have it do some installing and it's down to 20 minutes.

It is not (yet) the common 600-series battery failure, the battery meter goes down steadily one by one, no big drop from 90% to 30% or so.

On the one hand a drop is to be expected, I suppose - even when idle the new CPU is running faster than the old one at full power. Still, this is quite drastic, and I am seriously considering a downgrade again, as the machine cannot really be used unplugged any more. Has anyone else experienced this? Is it possible to slow the CPU down to less than 700MHz?

Björn

Rob Mayercik
Junior Member
Junior Member
Posts: 262
Joined: Tue Sep 28, 2004 6:50 am
Location: NJ, U.S.A.

#2 Post by Rob Mayercik » Wed Dec 20, 2006 8:30 am

Is the unit generating an abnormal amount of heat with the "new" processor (fan running continuously)?

Is it possible you might have caused a tiny short during installation, such as thermal paste oozing out from under the fan?
T61p 8891-CTO
TP600 2645-45u (Upgraded to PII-400)

Grey Area
Freshman Member
Posts: 76
Joined: Mon Sep 19, 2005 12:02 pm
Location: Koblenz, Germany

#3 Post by Grey Area » Wed Dec 20, 2006 9:55 am

Hmm, interesting idea, I will have to check this tonight. Usually I pay no attention to the fan, so I don't really remember if it is on all the time. I did use a thermal pad instead of paste (there are tiny spacers between fan and CPU, would have required lots and lots of paste to fill the gap), but pads are a bit suboptimal as far as I know. Maybe I need to work out an alternative there. Thanks for the hint!

Björn

Rob Mayercik
Junior Member
Junior Member
Posts: 262
Joined: Tue Sep 28, 2004 6:50 am
Location: NJ, U.S.A.

#4 Post by Rob Mayercik » Wed Dec 20, 2006 5:21 pm

I shouldn't think the fan by itself would be responsible for such a vast drop in run time, but it might be a symptom.

Certainly it's worth checking out.
T61p 8891-CTO
TP600 2645-45u (Upgraded to PII-400)

Grey Area
Freshman Member
Posts: 76
Joined: Mon Sep 19, 2005 12:02 pm
Location: Koblenz, Germany

#5 Post by Grey Area » Sat Dec 23, 2006 8:07 am

After switching various CPUs back and forth for a while and dragging in a second 600x for comparisons, I am now quite certain that it is the battery's fault after all, in spite of my first statements. A rather stupid coincidence, it is merely a month old (genuine ebay-noname-brand, though :wink:) and must have started failing right between the old and the new CPU. So, potential modders, don't let my experience stop you, the CPU is fine.

Björn

Post Reply
  • Similar Topics
    Replies
    Views
    Last post

Return to “ThinkPad Legacy Hardware”

Who is online

Users browsing this forum: No registered users and 2 guests