Keyboard

Message

ctohang · #1 Post by **ctohang** » Sat May 19, 2007 9:56 am

My T40 keyboard Key "UIOP" doesn't have any respone, May I know why? If it need to replace, can I replace with the T60 keyboard?

agarza · #2 Post by **agarza** » Sat May 19, 2007 3:15 pm

Have you tried cleaning the keys, removing the letters and blowing compressed air in the area of where the keys are located.

polityk · #3 Post by **polityk** » Sat May 19, 2007 3:41 pm

I had it recently on any laptop I used for longer than 2 weeks

In my case it was always bread crumbs

I think It's something with IBM's design

ctohang · #4 Post by **ctohang** » Sun May 20, 2007 4:17 am

xtr wrote:Have you tried cleaning the keys, removing the letters and blowing compressed air in the area of where the keys are located.

I just cleaning it, but it still respone.

WarMachine · #5 Post by **WarMachine** » Sun May 20, 2007 5:05 am

Hello,

Do you have the same problem by using an external keyboard, or, if you don't have one, using the virtual keyboard :

1. Click on the Start Button,
2. Click on "Execute...", then type "osk" (w/out the quotes),
3. Click on <OK>.

What's happening then ?

If you don't have any problem using those two keyboards, then, it could be a problem with the internal connectors.

It would be intersting to verify that. You'll find how to do using the T40 HMM here :

http://www-307.ibm.com/pc/support/site. ... MIGR-46464

W.

Keyboard

Keyboard

Who is online