Can't open my memory bay door

Message

rocketman · #1 Post by **rocketman** » Sat Nov 20, 2004 11:08 am

I was all ready to add another 512mb of ram to my new T42. I turned it over removed the battery and tried to unscrew the memory bay door but it's screwed on so tight that I can't seem to get it open with any size philips head screwdriver. I'm afraid to strip the screw, actually I hope I didn't already . Does anyone have any ideas on what I can do to get it open?

rocketman · #2 Post by **rocketman** » Sat Nov 20, 2004 1:35 pm

I finally was able to get it open & installed the memory.

MadeInJapan · #3 Post by **MadeInJapan** » Sat Nov 20, 2004 2:40 pm

What did you have to do?

rocketman · #4 Post by **rocketman** » Sat Nov 20, 2004 2:59 pm

Nothing very technical, I pushed down a little on the door and had to put a little more pressure than I would have liked on the screw driver to finally get the screw out. Everything went fine after that, I'm running with 1gb of ram now. Got it from Crucial.

Kenn · #5 Post by **Kenn** » Sat Nov 20, 2004 5:29 pm

You need to turn the mic on.

"Open the memory bay doors, Hal."

Can't open my memory bay door

Can't open my memory bay door

Who is online