T40 System Update not launching

Message

delaneybob · #1 Post by **delaneybob** » Sat Jan 19, 2008 7:06 am

Hi,
I installed the Microsoft .Net 2.0 and installed the 3.1 version of System Update. Everything was OK. I launched System Update and get the start up GUI which lasts 10 seicnds and then goes away. I waited 10 minutes->relaunched->same issue.

Any ideas?

Thanks

delaneybob · #2 Post by **delaneybob** » Sat Jan 19, 2008 7:42 am

I am on a separate forum for Malware (run32dll.exe hitting disks all the time). I have manually stopped those processes which fixed it.

However the fan is still running all the time even with CPU at 0%

Thanks

Padhead · #3 Post by **Padhead** » Sat Jan 19, 2008 9:51 pm

I hd a similar problem with update, SO i reinstalled, and this time it worked.

delaneybob · #4 Post by **delaneybob** » Tue Jan 22, 2008 7:18 am

Hi
I ave uninstalled and then reinstalled- still the same. Do I need Microsoft 1.1 .NET instead ?

Padhead · #5 Post by **Padhead** » Tue Jan 22, 2008 10:54 am

It might need something you dont have installed. That Should be easy to figure out on their site in the requirements section.

Or perhaps an older version hasn't been uninstalled properly/completely

delaneybob · #6 Post by **delaneybob** » Wed Jan 23, 2008 10:17 pm

Hi,
I have all the prereqs. uninstalled and reinstalled. Then I downgraded to Microsoft .Net 1.1 and reinstalled still the same.

Thye have a 3.13 System Update that supposedly gives you indications of loading failures but never saw them.

Thanks

delaneybob · #7 Post by **delaneybob** » Sun Jan 27, 2008 7:30 am

Any ideas out there? Is there a debug or something to showwhy system update is not working?
Thanks

T40 System Update not launching

T40 System Update not launching

Also........

Who is online