Memory module doesn't fit?

[KasperSorensen]

Hello everybody

I have a Lenovo Thinkpad T61, 7664 with 2GBs of memory and the other day I ordered an additional GB memory. After looking through Lenovo's website I found that this would be the right one to buy:

http://www5.pc.ibm.com/dk/products.nsf/ ... p/_31P9834

I received it yesterday but when I tried to install it I found that the small hole in the chip did not match the tap on the computer perfectly and I couldn't fit in the memory module! I took this picture of it:

http://img395.imageshack.us/img395/9527 ... pilrd7.jpg

The small tap seems to be a couple of milimeters off... Have I chosen the wrong type of memory or is it a defect or am I doing something wrong?[/url]

[sjthinkpader]

Your new T61 takes PC2-5300 or higher. PC2700 only work until T42.

Try this table.

http://www-307.ibm.com/pc/support/site. ... MIGR-55644

[rkawakami]

That module in the picture is a DDR version. The T61 requires DDR2 modules. The difference is exactly what you see; the alignment notch in the edge of the module does not line up with the socket in the laptop. Here's a photo of the differences:

http://www.kawakami-ca.com/images/ddr_vs_ddr2_notch.jpg

The module you referenced at the Lenovo site is exactly what is said it was... DDR.