Can anyone repair an Ultrabay 2000 Guide Rail?

[RealBlackStuff]

Has anyone found a method to repair the Ultrabay 2000 Guide Rail?
I'm talking about the small angled support at the far right corner, that is held in place by a screw from the back. It sits above the release for the CD or Floppy or other Ultrabay device.
Any tips, tricks, hints, etc. are highly welcome.

[RealBlackStuff]

Has nobody tried it with e.g. liquid metal, Araldite, 2-component glue etc?

[rkawakami]

Just searched Google for this after reviewing our previous conversation:

bond aluminum

and these appeared in the list of hits:

How to bond aluminum to aluminum?
Metal Bonding
Adhesives bond aluminum, steel, galvanized metals to substrate

About the only way I can see something like these materials being used would be to bond a separate angled piece between the side of the Ultrabay cage and the top of the broken mounting tab. All of the ones that I have seen break at the bend where the aluminum has been turned 90 degrees (i.e., the weld of the tab to the cage frame is still intact).

[RealBlackStuff]

The JB Welding sounds the most promising, but there is not a lot to fill with that paste, without a metal 'filler'.
My son-in-law has access to metal-turning machinery.
He's going to make me some aluminum parts for that corner, a rectangular piece with a round cutout for the plastic bush from the hinge-cover. That piece should then be glued in the inside corner of the broken support.
I'll let you know when I get them, and if they work.