Kalyway 10.5.x on T61

[kachofool]

Hey all,

Been trying to get OS X on my T61. I can put Kalyway 10.5.2 on without any hitches, but when I try to update to 10.5.3 and then restart, OS X won't load.

I get an error message along the lines of x00 device not found.

I was using vanilla 9.2 and chose not to upgrade the kernel during the update.

Has anyone updated a T61 to 10.5.3 successfully? If so, could you please post what options you installed with, and what options you selected when updating (there were only two if I recall correctly).

My system specs:
Intel wireless, intel ethernet, Nvidia NVS140

Thanks!
KF

[slackwaresupport]

i used iATKOS newest out is v4i 10.5.4
i have a T61, but nothing works. no ethernet, no wireless, no audio, no gl on the video...
so its basically useless until some drivers get out.

[psybers]

Similar issues on T60p. Kalyway 10.5.2 installed without a hitch (sound isnt working, but wifi and bluetooth do). When I go to upgrade to 10.5.3 the boot either locks or reboots partway through.

It seems like my problem at least is that configd is crashing. Reading through the crash log though isn't giving me any insights.

[tomdabomb2u]

I have an R61i (8932) with Kalyway 10.5.2 installed and have sound, but no WiFi or ethernet. . .

Anyone know whether or not WiFi works with this hw???

[paOol]

Hey all,

Been trying to get OS X on my T61. I can put Kalyway 10.5.2 on without any hitches, but when I try to update to 10.5.3 and then restart, OS X won't load.

I get an error message along the lines of x00 device not found.

I was using vanilla 9.2 and chose not to upgrade the kernel during the update.

Has anyone updated a T61 to 10.5.3 successfully? If so, could you please post what options you installed with, and what options you selected when updating (there were only two if I recall correctly).

My system specs:
Intel wireless, intel ethernet, Nvidia NVS140

Thanks!
KF

Hey i have a T61 also

Quadro 140m, atheros wifi, and i think intel ethernet.

anywho, i have the Kalyway 10.5.2 disc also, but when i installed it, i see the mac welcome video (says welcome in all the diff languages) then i get about 3 steps in for the beginning screens. after the third screen (importing anything from previous macs), i hit continue and it restarts from the welcome video again, and the process just repeats.

i have installed with the default kernel and the kabylkernel.

what drivers and stuff did you customize when installing? or did u just use defaults