Hi everyone,
First post here, and I am looking for some help. My T42 has been having some problems recently. If I lift the laptop and place it back on the table, or accidentally move it, the screen goes blank. Sometimes, only the screen goes blank but the computer is still very much running. Other times, it restarts by itself. I read over the STICKY that implies that this might be a bad solder joint problem, but I wasn't sure.
What do you think? Is it a bad solder joint problem? I have already opened up the LCD and reconnected the ribbon cable from the back of the LCD going to the motherboard, and this seems to have improved the situation slightly. Now, if I move the laptop screen, its fine. When I am lifting it or placing it, the same issue still exists. Any help would be greatly appreciated.
T42 blank screen problem
-
ajkula66
- SuperUserGeorge

- Posts: 15742
- Joined: Sun Feb 25, 2007 11:28 am
- Location: Brodheadsville, Pennsylvania
Welcome to the forum!
I suggest that you re-read the sticky "my T42 shuts down when I move it" at the top of this thread...
If that's how your machine is behaving, you're in for GPU re-balling or motherboard replacement, no question.
Good luck.
I suggest that you re-read the sticky "my T42 shuts down when I move it" at the top of this thread...
If that's how your machine is behaving, you're in for GPU re-balling or motherboard replacement, no question.
Good luck.
...Knowledge is a deadly friend when no one sets the rules...(King Crimson)
Cheers,
George (your grouchy retired FlexView farmer)
AARP club members:A31p, T43pSF
Abused daily: T61p
PMs requesting personal tech support will be ignored.
Cheers,
George (your grouchy retired FlexView farmer)
AARP club members:A31p, T43pSF
Abused daily: T61p
PMs requesting personal tech support will be ignored.
Welcome to the forum!
...although "the circumstances" why you are here might not be the most happy...
As George says above, and as you have also already researched yourself, things seems to point towards that the (in!)famous "loose GPU problem" has also stuck you..
Then, what to do? First, don't panic - there are absolutely help to get, and your T42 may still have many good years ahead. If I were you, I would first go to the IBM Warranty Lookup page and check if your T42 is still under warranty - if so, you'll know what to do!
If however out of warranty, and unless you are not yet quite set for taking the "final" step towards a motherboard repair, but wants to check all other possibilities (other weakly potential causes), then go to the thread T42p won't come out of standby or won't boot after shutdown and see the post of Sun Feb 10, 2008 12:16 pm - and follow those steps. If none of this shows any errors, I guess you're out of luck... and your motherboard has to be repaired. But: Where to do this, if you don't want to try your own luck, attempting a "home-repair"? In relation to having some experienced repair-shop helping you, you may want to have a look in the threads GPU Problem Fix pointing to the company Superior Reball - their own homepage is here. Also, see the thread T42 shuts down when I move it and especially see the post by "bblesser" of Wed Aug 20, 2008 3:31 pm and the post by "dieselman8" of Mon Feb 04, 2008 3:42 pm and finally see the same thread, the post by "dozer" of Thu Nov 29, 2007 2:01 am pointing to First Phase Technologies.
Best of luck with getting your T42 back on its feet!
Johan
...although "the circumstances" why you are here might not be the most happy...
As George says above, and as you have also already researched yourself, things seems to point towards that the (in!)famous "loose GPU problem" has also stuck you..
If however out of warranty, and unless you are not yet quite set for taking the "final" step towards a motherboard repair, but wants to check all other possibilities (other weakly potential causes), then go to the thread T42p won't come out of standby or won't boot after shutdown and see the post of Sun Feb 10, 2008 12:16 pm - and follow those steps. If none of this shows any errors, I guess you're out of luck... and your motherboard has to be repaired. But: Where to do this, if you don't want to try your own luck, attempting a "home-repair"? In relation to having some experienced repair-shop helping you, you may want to have a look in the threads GPU Problem Fix pointing to the company Superior Reball - their own homepage is here. Also, see the thread T42 shuts down when I move it and especially see the post by "bblesser" of Wed Aug 20, 2008 3:31 pm and the post by "dieselman8" of Mon Feb 04, 2008 3:42 pm and finally see the same thread, the post by "dozer" of Thu Nov 29, 2007 2:01 am pointing to First Phase Technologies.
Best of luck with getting your T42 back on its feet!
Johan
IBM T42p's (2373-Q1U & -Q2U): 2.1 GHz, 15" UXGA FlexView, 2 GB RAM, 128 MB FireGL T2, 128 GB 1.8" SATA SSD, IBM a/b/g, BT, Win 7 Ultimate
IBM T42 (2373-N1G): 1.8 GHz, 15" SXGA+ FlexView, 2 GB RAM, 64 MB Radeon 9600, 64 GB 1.8" SATA SSD, IBM a/b/g, BT, Win 7 Ultimate
IBM T42 (2373-N1G): 1.8 GHz, 15" SXGA+ FlexView, 2 GB RAM, 64 MB Radeon 9600, 64 GB 1.8" SATA SSD, IBM a/b/g, BT, Win 7 Ultimate
Hi Johan & George,
Thanks for pointing me in the right direction. I love my T42 (and I bought it used too!), so I am going to put in the effort and patience required to get it back to running properly. I have been reading through the sticky thread as pointed above, and I will definitely look into the easier fixes first. I will have an update once I get settled into my new apartment and get my life back together. Thanks again, and I will keep the thread updated.
Thanks for pointing me in the right direction. I love my T42 (and I bought it used too!), so I am going to put in the effort and patience required to get it back to running properly. I have been reading through the sticky thread as pointed above, and I will definitely look into the easier fixes first. I will have an update once I get settled into my new apartment and get my life back together. Thanks again, and I will keep the thread updated.
-
- Similar Topics
- Replies
- Views
- Last post
-
-
T410i won't boot (no beep, power LED on, LCD blank) (2518F5U)
by scootley » Mon Jan 09, 2017 10:55 pm » in ThinkPad T400/410/420 and T500/510/520 Series - 11 Replies
- 1172 Views
-
Last post by RealBlackStuff
Thu Jan 12, 2017 2:19 pm
-
-
-
Lenovo support draws a blank on my build # / serial
by glossywhite » Fri Jun 02, 2017 8:38 pm » in ThinkPad R400/R500 Series - 12 Replies
- 607 Views
-
Last post by ajkula66
Tue Jun 06, 2017 7:09 pm
-
-
-
WTB T60p or Frankenpad with 1600x1200 Screen ; also looking for a T42 fan
by smashkenazi » Sat May 13, 2017 8:15 am » in Marketplace - Forum Members only - 7 Replies
- 529 Views
-
Last post by burnsidr
Thu Jun 15, 2017 1:57 pm
-
-
- 7 Replies
- 1866 Views
-
Last post by RealBlackStuff
Wed Jan 04, 2017 11:29 am
Who is online
Users browsing this forum: No registered users and 7 guests




