Just resurrected a T30, status LED's not working.. :(

Message

flyonthewall · #1 Post by **flyonthewall** » Mon Dec 29, 2008 1:29 pm

So I just finished putting a good bottom half with a good screen to make one complete T30. Everything's working fine, except for the status LED's (battery/ charging/ HD/ bluetooth/ suspend) on the inside panel and on the outside of the screen case.

I know I hooked everything up that should have been, what else could I have missed??

sjthinkpader · #2 Post by **sjthinkpader** » Mon Dec 29, 2008 1:36 pm

Either fuse or transistors on the MB.

flyonthewall · #3 Post by **flyonthewall** » Mon Dec 29, 2008 1:39 pm

[censored].. guess i'll just deal with it, i don't wanna pull that thing apart again!

#4 Post by **RealBlackStuff** » Mon Dec 29, 2008 2:28 pm

Could also be a bad or not properly seated LCD cable...

flyonthewall · #5 Post by **flyonthewall** » Mon Dec 29, 2008 5:30 pm

hmm, i clicked it in there firmly and put the screw in to ensure that it wouldn't move.. is there a certain way to connect it?

sjthinkpader · #6 Post by **sjthinkpader** » Mon Dec 29, 2008 8:10 pm

flyonthewall wrote:... i don't wanna pull that thing apart again!

I finally broke down and bought a cordless screw driver. Just a cheap $20 B&D and it works fine. T2x are much simpler compared to T4x.

Just resurrected a T30, status LED's not working.. :(

Just resurrected a T30, status LED's not working.. :(

Who is online