A30 cannot load window XP error message

[kewele]

Dear All ,
i am just joint the forum, excuse me for my bad english , i am french .
I have just purchased a used motherboard for my "lovely" A30 .
Now i am facing to more problems, the computer is completly assembled and when i try to install window XP it stucks.
I have run PC doctors and no defect will be fund out.
I have updated the bios tothe latest one without problem.
But now iff i go in the Bios setup the UUID is set at FFFFFFF
I can't understand why! :
When i start the computer i have the following message:
Invalid RFID Configuration Information Area !!!
If i put a dos disk it will boot on without problem after pushing ESC pad.
Can somme one help me to go out off that situation?
Best regards :

[Harryc]

We do not allow cross (duplicate) posting on the forums. I am locking this thread.