X60 with NHC

[jiopsi]

Installed NHC in X60 and its working good, but can't access ACPI control system? Is there ACPI-files separetely for X60?

[sojourner]

Installed NHC in X60 and its working good, but can't access ACPI control system? Is there ACPI-files separetely for X60?

Yes, there are!

When NHC installs it defaults installation to
\Program Files\Notebook Hardware Control

Under that DIR there should be a \ACPI directory.
Look in there for files named LENOVO, specifically lenovo_mod.
Open lenovo_mod (double click, should open with notepad)
change the model name between the "" marks to the model of your TP.
SAVE

Restart NHC, ACPI settings will be available

[jiopsi]

Mine didn't install those by default but found combatible. The problem was bottom has two numbers:

1706CTO
1706W3Q

, and I was trying with CTO every time and it didn't work, but the other worked. What is the difference with these numbers btw?

[pkiff]

The problem was bottom has two numbers:
1706CTO
1706W3Q
[...]What is the difference with these numbers btw?

CTO = custom configuration. It could mean almost any hardware combination at all. The other three are a standard model config with specific hardware listed by Lenovo.

Phil.

[sojourner]

Mine didn't install those by default but found combatible. The problem was bottom has two numbers:

1706CTO
1706W3Q

Glad you got it working. BTW, you can add multiple models, as follows:

<Model name="1706cto" location="MAINBOARD" class="TPFancontrol" file="lenovo.cs" />
<Model name="1706w3q" location="MAINBOARD" class="TPFancontrol" file="lenovo.cs" />

[jiopsi]

Ok, thanks for the info.