X61s broken lamp incident

X60/X61 series specific matters only.
Post Reply
Message
Author
Philippe Laurichesse
Posts: 29
Joined: Sun Aug 24, 2008 9:52 pm
Location: Paris, France

X61s broken lamp incident

#1 Post by Philippe Laurichesse » Wed Oct 27, 2010 2:19 am

A glass lamp dropped from a shelf onto the table where my laptop (Thinkpad X61s) was. Tiny little pieces of broken glass all over the surface. I cleaned it all up - but my worry is that little glass shards - many of them as small as a grain of salt - might have got into the laptop, especially the fan vent opening that was facing the shelf where the lamp stood before it fell. Should I be worried ? I am not into the habit of taking apart my laptops, and even if I was, I don't think it would be possible to get out any grain-sized glass shards from the maze of circuits, etc. (The grain-sized bits of glass are so small they have a tendency to stick to surfaces, thereby complicating the issue.) My guess is that a few (5 ? 10 ?) grains got into the vent opening - if any got in at all. My fear is that when I use the laptop and it gets hot inside something bad might happen. Glass melts at a high enough temperature that I probably don't have to worry about it melting inside my laptop, but I wonder if it might nevertheless have other adverse effects. Someone please put my mind at ease - or tell me I'm doomed. The uncertainty is killing me.

rkawakami
Admin
Admin
Posts: 10052
Joined: Sun Jun 04, 2006 1:26 am
Location: San Jose, CA 95120 USA
Contact:

Re: X61s broken lamp incident

#2 Post by rkawakami » Wed Oct 27, 2010 2:51 am

Glass is electrically non-conductive so you wouldn't have any problems with pieces shorting out the circuitry. What could be a problem is if some got into the fan assembly and impacts against the fan blades. Worst case is that a big enough piece could jam the fan and/or break a blade. The best case is that the spinning fan ejects the piece of glass out of the case.

In any event, what I would do is vacuum the system as much as possible; keyboard and vent areas in particular. If you don't feel comfortable with taking it apart, then do the best you can. Be aware that sucking air out of the vent(s) could make the fan spin faster than what it is designed for. To minimize any potential damage, tilt the laptop so the vent is pointed downward and that should allow any loose piece to fall out of the system. Use a low/slow speed setting on the vacuum around the vent(s).
Ray Kawakami
X22 X24 X31 X41 X41T X60 X60s X61 X61s X200 X200s X300 X301 Z60m Z61t Z61p 560 560Z 600 600E 600X T21 T22 T23 T41 T60p T410 T420 T520 W500 W520 R50 A21p A22p A31 A31p
NOTE: All links to PC-Doctor software hosted by me are dead. Files removed 8/28/12 by manufacturer's demand.

richk
Moderator
Moderator
Posts: 2911
Joined: Sun Jan 01, 2006 3:29 pm
Location: San Francisco, CA

Re: X61s broken lamp incident

#3 Post by richk » Thu Oct 28, 2010 10:08 am

I think it is VERY unlikely to cause a problem

Woodenspoon
Freshman Member
Posts: 69
Joined: Sat Oct 30, 2010 1:07 am
Location: San Jose, Calif. USA

Re: X61s broken lamp incident

#4 Post by Woodenspoon » Sat Oct 30, 2010 4:45 am

Turn system off, get a vacuum cleaner, apply the hose nozzle to any intake or vents the glass might have gotten into, it is likely they will survive that.

Post Reply
  • Similar Topics
    Replies
    Views
    Last post

Return to “Thinkpad X6x Series incl. X6x Tablet”

Who is online

Users browsing this forum: No registered users and 4 guests