Thinkpad 600X ...Errors

Older ThinkPads.. from the 600, the 7xx, the iSeries, 300, 500, the Transnote and, of course, the 701
Post Reply
Message
Author
mirka
Posts: 15
Joined: Fri Jan 21, 2011 1:34 pm
Location: Reutlingen, Germany

Thinkpad 600X ...Errors

#1 Post by mirka » Fri Jan 28, 2011 10:09 am

Hello,
found an old 600X on the shelf.
Power on says ERROR 0178 0193 0194 0188 0188 2 short beep´s than 0163 .

Shell I spend time on this anny longer ... or should I trogh it to junk ??

Can not get in to "Smart setup" (BIOS)
I have read the Atmel Chip there in no superviser-passwort in !! all YYYYYYYYYY

See you Mirka
Sorry for printingfoults
Last edited by mirka on Sat Jan 29, 2011 10:17 am, edited 1 time in total.

RealBlackStuff
Admin
Admin
Posts: 17508
Joined: Mon Sep 18, 2006 5:17 am
Location: Mt. Cobb, PA USA
Contact:

Re: Thinkpad 600X ...Errors

#2 Post by RealBlackStuff » Fri Jan 28, 2011 5:13 pm

Start with replacing the CMOS battery, that one is definitely dead.
Most, if not all of your errors will be gone after that (and setting date/time).
Lovely day for a Guinness! (The Real Black Stuff)

Check out The Boardroom for Parts, Mods and Other Services.

mirka
Posts: 15
Joined: Fri Jan 21, 2011 1:34 pm
Location: Reutlingen, Germany

Re: Thinkpad 600X ...Errors

#3 Post by mirka » Sat Jan 29, 2011 4:03 am

Hi,
replaced BIOS Battery by a new one ..... same as befor ...
also IBM Code sayes 161 / 3 Systen board failure ..
sorry ... Best regards Mirka

pkiff
Moderator
Moderator
Posts: 1426
Joined: Wed May 05, 2004 9:17 am
Location: Toronto, Canada

Re: Thinkpad 600X ...Errors

#4 Post by pkiff » Sat Jan 29, 2011 8:47 am

Mirka,

You've probably already looked at the error code listing here:
http://www-307.ibm.com/pc/support/site. ... wik-3sr4pw

This page suggests an issue with your EEPROM: "178: EEPROM is not functional." And IBM's recommendation is to replace your motherboard.

Several of your other error codes aren't in the list above. And the last one (0163) usually just means you should replace the CMOS battery as RealBlackStuff suggested.

I don't have any suggestions, but thought I'd send along a link to the error code listing in case you hadn't already looked at it.

Edit: I just double-checked and the Hardware Maintenance Manual actually contains a couple additional error code explanations that don't appear on the page linked above.

----

193
RF Antenna has been
removed.

1. Type the correct
supervisor password
at the password
prompt.
2. Reseat the RF
Antenna to the HDD
cover.

----

194
The computer is carried
through the portal gate.

1. Type the correct
supervisor password
at the password

----

188, 189
BAD EEPROM CRC #1. An
incorrect checksum of the
EEPROM is received.

1. System board.

-----

All roads seem to point towards replacing the motherboard/system board.

Phil.
W520 (dual-boot Windows 10/Ubuntu 15) · X61 Tablet SXGA+ · T60p UXGA · Legacy: X60T, 600X, 770Z
Thinkpad Media Centre: X61T running XBMC with Broadcom Crystal HD BCM970015, Creative X-Fi Surround 5.1 plugged into Cambridge Audio Sonata AR30 receiver

mirka
Posts: 15
Joined: Fri Jan 21, 2011 1:34 pm
Location: Reutlingen, Germany

Re: Thinkpad 600X ...Errors

#5 Post by mirka » Sat Jan 29, 2011 10:26 am

Thanks very much for your help.
600X has no WI FI just a 56k Modem.
A fully functional 600X is at Ebay. de for abt. 60 $ so for me it does not pay off.
I would make more money ...going to SUPERMARKET and fiilling shelfs.
I think, I will offer it to an enthusiast who likes to disesamble it, taking the good parts for repar.

Best Regards Mirka

Post Reply
  • Similar Topics
    Replies
    Views
    Last post

Return to “ThinkPad Legacy Hardware”

Who is online

Users browsing this forum: No registered users and 6 guests