I have 60/10 connection, I don't think my old 10/100 linksys can handle those kind of speeds because I max out around 3.50 megabytes via wan port not wireless. Sorry the topic has changed since I found out that I could load tomato firmware on my old wrt54g v2. I was so ready to put the dlink aside f...

So I i get around 3.58 megabytes. Does this router have a hardware limitation on the wan port? If this is the case this firmware won't do me any good.

I noticed this tomato firmware is limiting my bandwidth, I have 60mb connection, and I am only getting less then 2mb per sec. Is there any configure I need to fix?

So I was able to get the firmware loaded to my wrt54g. I set up up wireless bridge with my d link so I am going to test my atheros card.

Has anyone run into problems after installing and dock programs,ubuntu begins to act weird? Not sure its a video card problem or a driver issue after installing docky, my screen sporadically flickers and goes blank.I have end up rebooting to get back into ubuntu. I started to notice this behavior af...

I still have my wrt54g, I stopped using it because some of the ports stopped working. I have one of the earlier aps, maybe I can put it back to use. Is tomato some kind of hacked firmware? I think I have a wrt54gv2

Are you not a fan of dlink? I had a similar problem with my linksys wrt54g way back when, that is one of the reasons I switched over.

I didn't have many problems with the intel card, I only got the atheros card because I was planning on building a hackintosh. That project got scrapped and decided to give ubuntu another try. I don't know if its a driver thing or my AP is picky with the cards. I've had experience where certain AP di...

It appears power management is already off. wlan0 IEEE 802.11abgn ESSID:"Heath St" Mode:Managed Frequency:2.462 GHz Access Point: 00:1C:F0:EF:90:5A Bit Rate=54 Mb/s Tx-Power=20 dBm Retry long limit:7 RTS thr:off Fragment thr:off Power Management:off Link Quality=70/70 Signal level=-32 dBm Rx invalid...

Its a thinkpad card so no need for a bios hack. I swapped it out with my intel card.

How can I tell if I have the most up to date driver?

I still have my old intel abg card, I swapped it out for the atheros. Should I just throw that back in there?

A couple of options come to mind: 1) Check wireless power settings and try disabling power management: > iwconfig wlan0 wlan0 IEEE 802.11abgn ESSID:"Neutrino" Mode:Managed Frequency:2.462 GHz Access Point: XX:XX:XX:XX:XX:XX Bit Rate=1 Mb/s Tx-Power=15 dBm Retry long limit:7 RTS thr:off Fragment thr...

I recently installed 10.4 on my t60 and I noticed I am not getting the best performance with my wifi. I am running into problems where I sporadically drop connections, the range isn't so great and at time it there is a delay connecting to websites. Is there any other drivers I could use to help this...

I am getting 16 secs boot up with ubuntu 10.4 on my T60 and I have 60gig ssd.

The post doesn't really give good info on how to install the 3rd antenna.

I think there are some kexts file from bozilla kext package, that is causing the kernel panics. I am using some of the kexts from the Vanilla_10.6.2_t60p_2007cq8_pkg.zip. I am not sure if there is much difference between the T60 and T60p kext files. I want to find the correct basic kexts for the T60...

What screen would you like to see?, I know this is a silly question but how do I insert a photos here? I don't see a insert option here to upload photos.

I ran into another kernal panic again, I did the -v like you mentioned before the gray boot up screen. I get a little boot: section in the lower left hand corner, but its not clear what I need to do from here.

Is there any way to change my resolution its stuck at the 1024 x 768?

sjthinkpader wrote:I got my antennae on eBay. At the time, most were made by Hitachi Cable and Foxconn.

Do you have any instructions on how to install it?

Where can I get one of these antenna's?

I installed a atheros N card a few days ago, everything works fine, except I don't have a third antenna installed. Is the third antenna necessarily needed to use the card in N mode? I plan on getting another screen for my T60, should I just add the antenna when do a screen swap?

What do you mean when you say boot from -v? I am suppose to hit "-v" at the gray boot up screen to see the log?

Finally! Thanks man now does it matter which folder I place the kext files in, can I place them all in the EE folder? Now when I reboot, I keep getting gray apple screen, what could be the cause of this, is this a kernal panic LOL?

I downloaded the thinkpadultranav for the mouse and keyboard, inside the main folder there are two sub folders, one names "snow_i386-x64". Inside contains the thinkpadultranav.kext, I placed the kext that into the extensions folder and then rebooted, now my T60 hangs at the grey apple screen. What a...

Thanks!

This is my first hackintosh andI think I am starting to get the hang of this a tiny bit, but I am running into problems with the keyboard and mouse. I am using a usb kboard and mouse as the work around until I can get this figured. I was able to get sound and a few other drivers loaded by using the ...

I've start to read over this a little bit. Does it matter if I have not used the usb method? I did a straight dvd install using Empire and installed the fix. Thats where I am at as of now. I can only use a keyboard and usb mouse because the t60 keyboard stopped working after I applied the boot loade...

Used Empire EFI and a "factory" OS 10.6 disc to get my Thinkpad T60 (2007) running. I did get the ethernet to work. If I boot from the EFI CD first, then 10.6 from the HD, the keyboard and trackpad work fine... but if I boot soley from the HD, neither work (USB mouse/kb do) What should I be looking...