I like the small form factor of 14" 4:3 with good vertical screen space. But the wide screen is not too bad for now.
I do have several more permanent solutions, but not sure which route to go. These are some parts I have available.
2x 15" 4:3 T60 machines (I may also have a high res LCD screen available, but both are currently only XGA)
1x 4:3 Intel T61 motherboard with T9300 (I think that is the cpu) with modified bios
15.4" WS T61 NVS140 (I am using this now)
15.4" WS T61P (very busted up plastics, but I could swap the MB and screen into the chassis I am using now)
I also have a couple W500s with locked bios that I could salvage with bypass hack that probably is intense as any of the other mods I would be doing.
What routes would you take to get a nice quality T61 or better back into play with these parts?
Thanks in advance.
IBM T42 (2373-JTU) - 1.7GHz/1GB - HM160HC IBM 560x - 233MHz/96MB IBM 701c
Lenovo T601 (8897/2007) - T9300 - 4GB - 32GB SSD - Xubuntu 14.04
- Posts: 16833
- Joined: Sun Feb 25, 2007 11:28 am
- Location: Brodheadsville, Pennsylvania, USA
If you like the 14"/4:3 size, just get another screen or an entire LCD assembly. Someone on this forum must have one sitting somewhere.
FrankenPadding is your next best option if you don't mind the bulk of a 15" system.
Other than that, get a T410/420 for less than $100 and enjoy, presuming that you're OK with their screen ratio(s).
My $0.02 only...
George (your grouchy retired FlexView farmer)
FlexView AARP club members:A31p, T43pSF
Abused daily: T520, X200s
PMs requesting personal tech support will be ignored.
- Senior ThinkPadder
- Posts: 2556
- Joined: Mon May 28, 2012 5:49 am
- Location: Metro Manila, Philippines
Backup: X601 Core 2 Duo T8100
Toy: X60F Core Solo U1300
On loan: X220 4291-P79 i5-2520M
In pieces: two retired but working X61Ts
RIP: 760XD 9546-U9E; X61 7676-A24; and a BOE-Hydis HV121P01-100 in failed SXGA+ mod
- Similar Topics
- Last post
Who is online
Users browsing this forum: No registered users and 10 guests