Problem with TP600E

Message

Banshee · #1 Post by **Banshee** » Sun May 16, 2004 1:02 pm

Hi,
my TP600E brings an error (code 01201) everytime I swich it on.
I was on the IBM homepage, but I need a modell and machine type to get help there and I don't have them.
Where can I look which kind of error this is, or does any1 know the problem?

sktn77a · #2 Post by **sktn77a** » Sun May 16, 2004 1:29 pm

Never seen that error before. Is there a dash between any of the numbers?

http://www-307.ibm.com/pc/support/site. ... WIK-3SR4PW

Banshee · #3 Post by **Banshee** » Mon May 17, 2004 11:37 am

ok, I checked the bios and i found out, that the serial port, the infra-red and the parallel port are damaged:
serial port: dev 011; err 10; FRU 0010
infrared: dev 103; err 08; FRU 0010
parallel port: dev 009; err 01; FRU 0010

sktn77a · #4 Post by **sktn77a** » Mon May 17, 2004 2:04 pm

Try replacing the backup battery first. Some weird BIOS errors come up when the backup battery gets low.

Banshee · #5 Post by **Banshee** » Tue May 18, 2004 9:46 am

Ok I already heard that this could be the problem, but i wasn't rather sure, and I need to know where the backup batterie is, and what kind of batterie it is.

sktn77a · #6 Post by **sktn77a** » Tue May 18, 2004 11:52 am

It's a $1.25 CR2025 with two wires and a small plug welded to it. (Translation - IBM charge you $12.00 plus $8.00 shipping).

Bill might have them in stock but IBM probably charge him an arm-and-a-leg wholesale for it, too!

Banshee · #7 Post by **Banshee** » Tue May 18, 2004 1:05 pm

thanks, but I already tested another backup batterie, and now I get some more errors: 1201, 1101, 163
I'm not sure, perhaps the mainboard isn't ok...

Problem with TP600E

Problem with TP600E

Who is online